*Click the image above to view contents in PDF form.Sunday October 16, 2011Event Sponsored by RONA, Schumacher Racing, Xtreme R/C and Much Hobby.*Schedule of Events:
Registration / Practice..... 08:00am - 10:00am
Qualifying Round #1......... 10:00am - 11:30pm
Qualifying Round #2......... 12:00pm - 1:30pm
Qualifying Round #3......... 1:30pm - 3:00pm
Main Heats.................. 3:30pm - 5:30pm
Awards Presentations........ 5:30pm - 6:00pm
*Schedule subject to change based on event participation.
We have a busy day of racing planned, especially with the longer heats for the mains. As a result, racing will start at 10:00am. If you are not ready to run when your heat is called, the race will have to start without you to keep on schedule. We will complete 3 rounds of qualifying with a resort after each round.Entrance Fees:$25.00 - 1st Class
$ 5.00 - Each additional class.
There is no limit on the number of classes you may enter.Tophies/Medallions:A Main Winners (1st, 2nd, 3rd) - Trophy
B, C Main Winners (1st, 2nd, 3rd) - Medallion
Top Qualifer (each class) - Medallion
Only classes that have 6 or more registered drivers on or before midnight Sunday October 9th, 2011 will be eligible for the trophy event. Please see REGISTRATION for more information.Special Instructions:Please read the following carefully:
To keep heats flowing through each round, we will need drivers to proceed directly to marshall the next heat.
Tables will be provided solely for the purpose of placing your radio and car on as you leave the drive stand after your heat.
Pitting Arrangements:We need to adjust the pitting / parking practices slightly. These changes are permanent and will be enforced for this event and for the 2012 season.
There is a solid yellow line on the ground just east of the drive stand. All pit areas must be confined to the parking area east of that line.
All vehicles must be parked west of that line but no less than 10' from the drive stand.
If you need/wish to pit near your vehicle, the park in a space adjacent to the yellow line and pit in front of your vehicle on the east side of the line.
We will be roping off vehicle access to the pit area and the area immediately north of the track to keep pedestrians, spectators, and participants safe from vehicles creeping in to get a closer look.
We will have the areas for pitting and parking designated on Sunday morning. If you are on-site before DRCRC Officials, please wait to set up your pit station or be prepared to move if required.
Special Offer:
DRCRC Has a limited supply of Schumacher Sorex Pre-Mounted Tires available to DRCRC and Finale Racers for a special price of $40.00 Tax. Incl.
We have 28, 32 and 36R with various inserts.
Supply is limited. First Come, First Serve.Registration:Special Notice: Only classes that have 6 or more registered drivers on or before midnight Sunday October 9th, 2011 will be eligible for the trophy event.Registration can be done here:
RC Signup, or via
Facebook. Alternatively, you can let us know by replying to this thread. We will keep a running tab here for convenience:
Registered Drivers: GT1: Ryan Jimenez, Bill Bowden, Mike Vieira, Adam Hutchison, Franky Chan, Con VanGalen
GT2: Bill Bowden, Bill Bowden Sr., Michael Bourque, Jim Demmings, Len Schinzano, Mark Richardson, Dave Dwyer, Justin Sabat, Mike Vieira, Ray Ramnath, John Watkins, Con VanGalen
F1: Carlo Roman, Herbert Ramirez, Jimmy Lo, Danny Lo, Ray Ramnath, Adam Hutchison, John Watkins
Pan: Bill Bowden, Jim Demmings, Len Schinzano, Mark Richardson
Nitro: Carlo Roman, Ray Ramnath
1/8: Richard Pounder, Guy Rousse, Paul Brown
Class Rules:GT2
Motor: 21.5 Brushless
ESC: ROAR Approved Non-Timing
Chassis: Any Production 4WD Touring Car Chassis (1/10 Scale)
Body: Any 190mm Touring Car Body (including Super Touring). No Wedge/CanAm/Prototype bodies permitted
Battery: Any HardCase Lipo, Max 5000mAh, Max 40C
Tires: Any 1/10 Scale Touring Rubber, Any Insert, Any Rim.
FDR: No Limit.
Qualifier Length: 6 minutes
Main Length: 10 minutes
GT1
Motor: No restriction.
ESC: No restriction.
Chassis: Any Production 4WD Touring Car Chassis (1/10 Scale)
Body: Any 190mm Touring Car Body (including Super Touring). No Wedge/CanAm/Prototype bodies permitted
Battery: Any HardCase Lipo
Tires: Any 1/10 Scale Touring Rubber, Any Insert, Any Rim.
FDR: No Limit.
Qualifier Length: 6 minutes
Main Length: 10 minutes
Formula One
Motor: 21.5 Brushless or Tamiya Silver Can or Tamiya Black Can
ESC: ROAR Approved Non-Timing
Chassis: Any Production Formula-1 Chassis
Body: Any Realistic Formula-1 Scale Body
Battery: Any HardCase Lipo, Max 5000mAh, Max 40C
Tires: Any Formula-1 Foam or Rubber Tire, Any Insert, Any Rim.
Qualifier Length: 5 minutes
Main Length: 5 minutes
Nitro Touring
Engine: Any .12cc to .18cc Nitro Engine
FailSafe: Required
Chassis: Any Production 1/10 200mm Nitro Touring Chassis
Body: Any 200mm Touring Car Body (including Super Touring). No Wedge/CanAm/Prototype bodies permitted
Tires: Any 1/10 Scale Touring Foam
Qualifier Length: 5 minutes
Main Length: 10 minutes
Pan Car
Motor: 21.5 Brushless
ESC: ROAR Approved Non-Timing
Chassis: Any Production Rear Wheel Direct Drive Pan Car Chassis (200mm)
Body: Any 200mm Car Body (including Super Touring). No Wedge/CanAm/Prototype bodies permitted
Battery: Any HardCase Lipo
Tires: Any 1/10 Scale Foam Pan Car Tires
Qualifier Length: 6 minutes
Main Length: 6 minutes
1/8 Scale Touring
Chassis: Any Production 1/8 Scale Electric or Nitro Chassis
Body: Any 1/8 Scale Touring Car Body. No Wedge/Prototype Bodies
Qualifier Length: 6 minutes
Main Length: 10 minutes
* No Other Restrictions will be enforced for this class
* Heats may be split into Nitro and Electric if there are enough advanced registrations.
Register
Login